![](/images/new-backgrounds/1181918/1819185x1.webp)
Connections and Controls
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 |
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
υ | 1 | 2 | 3 | 4 | 6 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 |
Speaker Level Input |
|
|
|
|
|
|
|
|
| |||||||
ϖ | RCA Input (Left and Right) |
|
|
|
|
|
| |||||||||
ω | Gain (250mv to 5.0v - continuously variable) |
|
|
| ||||||||||||
ξ | Crossover Frequency Adjustment (50Hz to 200Hz - continuously variable) | |||||||||||||||
ψ |
|
|
| |||||||||||||
ζ | Crosssover Filter Switch (HP / Off / LP) |
|
|
|
| |||||||||||
{ |
|
|
|
|
| |||||||||||
Speaker Output Block (Left / Right) or (LF / RF / LR / RR on | ||||||||||||||||
} | Status LED (Blue = Normal / Red = Fault Mode) |
|
|
| ||||||||||||
∼ | Fuse (Replace with same value only, refer to specifications on page 2) | |||||||||||||||
| Power Block (12v / Remote / Ground) |
|
|
|
|
Status LED
The Boston Logo will illuminate “Blue” under normal operating conditions.
The LED will illuminate “Red” during
Speaker Level Input Cable
GTA amplifiers offer a dedicated speaker level input for ease installation into factory systems when an RCA (low level) signal is not available. Wiring code for the cable is industry standard;
White Solid = Left Positive | White w/ Black Stripe = Left Negative |
Gray Solid = Right Positive | Gray w/ Black Stripe = Right Negative |
Connections / Controls
Warning: Do not connect both Speaker Level and RCAs into the amplifier at the
same time as damage to the amplifier may occur.
3