EASY
ASSEMBLY
Assembling your Fast Tracker Metal Detector is easy and requires no tools. Just follow these steps:
●1 Using the supplied bolt and knurled knob, attach the search coil to the lower stem.
●2 Press the button on the upper end of the lower stem and slide the lower stem into the upper stem.
Adjust the stem to a length that lets you maintain a com- fortable upright posture, with your arm relaxed at your side. Maintain the search coil about 1 inch above the ground as you sweep.
●3 Wind the search coil cable around the stem. Leave enough slack in the cable to let you adjust the coil when you are hunting on uneven ground. Then tighten the knob at the end of the search coil.
Note: To adjust the coil, simply loosen the knob.
●4 Insert the coil’s plug into the matching connector on the control housing. Be sure the holes and pins line up correctly.
Caution:
•Do not force the plug in. Excess force will cause damage.
•To disconnect the cable, pull out the plug. Do not pull on the cable.
Search Coil
| Bottom side |
Search | Lower |
Stem | |
Coil |
|
Cable |
|
| Upper |
| Stem |
Lower |
|
Stem |
|
Plug
Upper
Stem 
Control
Housing
3
