Bowens BWL-0485 Mounting Ringflash Pro To Light Stand, Mounting Ringflash Pro To Camera Stand

MOUNTING RINGFLASH PRO TO LIGHT STAND

STEP 1.)	Mount the Camera Bracket to the selected support system as shown in fig. 1.
STEP 2.)	Once the Ringflash Pro is mounted onto the selected support system, simply tighten the mount screw as shown in fig. 2 to hold in
	position.

fig.1 fig.2

MOUNTING RINGFLASH PRO TO CAMERA STAND

STEP 1.)	To mount the Ringflash Pro to a camera stand, first place the brass spigot on top of the camera plate and fasten to the camera
	mounting thread as shown in fig. 3.
STEP 2.)	Next place the Ringflash Pro camera bracket on top of the brass spigot and lock in place by tightening the thumb screw as shown
	in fig.4.
STEP 3.)	Attach the Ringflash Pro to the camera bracket as shown in fig. 5 and secure in place using the thumb screws provided.
	N.B. When attaching the Ringflash Pro to the camera bracket ensure that the Ringflash Pro handle is positioned to one side to
	allow the Ringflash Pro complete freedom of movement without the handle coming into contact with the camera stand.
STEP 4.)	Once the Ringflash Pro is secured in place, next attach the camera to the camera bracket. Your setup should appear as shown in
	fig.6.

fig.3 fig.4 fig.5 fig.6

FLASHTUBE ASSEMBLY REPLACEMENT

		WARNING HIGH VOLTAGE
	AFTER USE DO NOT TOUCH THE FLASHTUBE ASSEMBLY FOR THIRTY MINUTES DUE TO EXTREME HEAT
STEP 1.)	Ensure that the Ringflash Pro is switched off and disconnected from the mains supply and wait for thirty minutes to allow to cool
	down before touching / removing the flashtube.
STEP 2.)	Before removing the flashtube assembly from the Ringflash Pro first remove the front protective glass cover (before removing
	check the glass has cooled sufficiently to touch). Once the glass cover has been removed take out the two modelling lamps
	next to the trigger wire tab and then unwind the trigger wire from the tab as shown in fig. 7. It is recommended to remove the two
	modelling lamps next to the trigger wire tab to allow more room to when unwinding the trigger wire and so not to damage the
	lamps.
STEP 3.)	To remove the flashtube assembly hold gently on both sides and pull away evenly from the Ringflash Pro as shown in fig. 8. To
	replace the flashtube assembly, simply place all four support legs into the correct fittings and gently push back in ensuring all four
	legs are placed back in evenly and secured by fully inserting into the flashtube leg connections.
	N.B. Always replace with the correct flashtube assembly.

fig.7 fig.8

MODELLING LAMP REPLACEMENT

	WARNING HIGH VOLTAGE
	AFTER USE DO NOT TOUCH THE MODELLING LAMPS FOR THIRTY MINUTES DUE TO EXTREME HEAT
STEP 1.)	Ensure that the Ringflash Pro is switched off and disconnected from the mains supply and wait for thirty minutes to allow to cool
	down before touching / removing the modelling lamps.
STEP 2.)	Before removing any modelling lamps from the Ringflash Pro first remove the front protective glass (before removing check the
	glass has cooled sufficiently to touch). To remove the modelling lamps grip gently between fingers (always ensure that you do not
	touch the modelling bulbs directly with your fingers, use a cloth or a tissue (as shown in fig.9.), this is because the residue from
	your fingers can shorten the life span of the bulb) and pull away slowly from the Ringflash Pro. To replace the modelling lamps
	simply align the two legs of the lamp with the correct fittings and gently push in ensuring that the lamp legs are fully inserted.

3

fig.9

4