Bradford-White Corp 238-44422-00G instruction manual Utility Models See Figure

Water Connections continued-

Utility Models (See Figure 2)

The hot and cold water connections are identified on the side of the water heater. Connect the hot and cold water lines to the installed nipples using unions. Install a listed temperature-pressure relief valve in the opening on the side of the water heater. Install a vacuum relief anti-siphon device in the cold water inlet line when using the side cold water connection.

The 6 and 12 gallon models are equipped for installation with either top or side water connections. They are shipped from the factory with side nipples installed and the alternate top connections plugged. For ease of conversion, the alternate top inlet is supplied with a dip tube. If the top water connections are needed, remove the installed side nipples and the pipe plugs from the alternate top connections. Install the nipples in the top water connections and install the pipe plugs in the side connections. Install a vacuum relief anti-siphon device in the cold water inlet when using the side cold water connection.

Figure 2

11