17" |
|
COMBI5500 | Installation Instructions |
Installation Instructions continued . . .
Step 3: Making Supply, Drain, and Waste Connections
NOTE: Flush all supply lines before making connections.
1.Make the water supply connection to the flush valve (piping supplied by installer).
2.Make the lavatory drain connections to the
3.Make the toilet waste outlet connections (piping supplied by installer).
4.Mount the valve assembly in the appropriate location and make the supply connections. Refer to the appropriate valve installation manual for actual assembly procedure (refer to Step 1, Procedure #2 on page 3 for installation manual part numbers).
5.Turn on the water supplies to the unit and check for leaking.
6.Press the lavatory pushbuttons several times to purge air from the lines.
7.Activate the flush valve several times to purge air from the lines.
Cleaning and Maintenance Instructions for Stainless Steel
Stainless steel is extremely durable, and maintenance is simple and inexpensive. Proper care, particularly under corrosive conditions, is essential. Always start with the simplest solution and work your way toward the more complicated. Daily or as often as needed use a solution of warm water and soap, detergent, or ammonia. Apply the cleaning solution per the manufactures instructions and always use a soft cloth or sponge to avoid damaging the finish. To remove stains from stainless steel use a stainless steel cleaner and polish such as Ball® stainless steel cleaner or a soft abrasive. Always follow the manufactures instructions and apply in the same direction as the polish lines.
IMPORTANT: NEVER USE ORDINARY STEEL WOOL OR STEEL BRUSHES ON STAINLESS STEEL. ALWAYS USE STAINLESS STEEL WOOL OR STAINLESS STEEL BRUSHES.
Special Situations for Material
To remove fingerprints or smears use a high quality stainless steel cleaner and polish in accordance with the manufactures instructions. Many of these products leave a protective coating the helps prevent future smears and fingerprints. To remove grease and oil use a quality commercial detergent or caustic cleaner. Apply in accordance to the manufactures instructions and in the direction of the polish lines. Avoid prolonged contact with chlorides (bleaches, salts), bromides (sanitizing agents), thiocyanates (pesticides, photography chemicals, and some foods), and iodides on stainless steel equipment, especially if acid conditions exist.
IMPORTANT: DO NOT PERMIT SALTY SOLUTIONS TO EVAPORATE AND DRY ON STAINLESS STEEL.
The appearance of rust streaks on stainless steel leads to the belief that the stainless steel is rusting. Look for the actual source of the rust in some iron or steel particles which may be touching, but not actually a part of the stainless steel structure.
NOTE: Strongly acidic or caustic cleaners may attack the steel causing a reddish film to appear. The use of these cleaners should be avoided. Use of brand names is intended only to indicate a type of cleaner. This does not constitute an endorsement, nor does the omission of any brand name cleaner imply its inadequacy. Many products named are regional in distribution, and can be found in local supermarkets, department and hardware stores, or through your cleaning service. It is emphasized that all products should be used in strict accordance with package instructions.
6 | 6/28/04 | Bradley Corporation • |
