Bradley Smoker E19-310DC Installation, Supplies Required, Secure base to floor

Figure 1

Installation E19-310DC

Installation				Ø 273mm
Supplies Required:				(10-3/4")
					247mm
• (3) M10 floor anchors and bolts					(9-3/4")
•	Teflon tape and pipe sealant				Ø 229mm (9") Flange
• Piping to 1-1/4" BSP water supply inlet on unit					with (3) Ø 10mm (3/8")
					Holes on Ø 203mm (8")
•	Adequate supply pipe supports				Bolt Circle
• Piping to 1-1/4" BSP drain outlet for eyewash				267mm
•	Minimum 102mm (4") drain to accommodate
				(10-1/2")
	115 liters (30 gallons) per minute discharge for		Use Teflon
	shower waste
			Tape Only
• OPTIONAL: sign-mounting hardware				645mm
Step 1: Secure base to floor			133mm	(25-3/8")
			(5-1/4")
	1. Install three suitable anchors (by installer)
	for M10 bolts in the floor (see Figure 1).				610mm
	2. Bolt the base to the floor anchors using M10				(24")
				Ø 254mm
	bolts (supplied by installer).			(10")
	IMPORTANT: Some teflon sealants				1676mm
					(66")
	may cause stress cracks in the plastic		2160mm		To
					Floor
	showerhead leading to failure. Use		(7'-1")
			To
	teflon tape for sealing the showerhead.		Floor	229mm	140mm
				(9")
Step 2: Assemble eyewash components					(5-1/2")
	1. Assemble the remaining unit components as
	shown in Figure 2 on page 4.
	•	Apply pipe sealant (supplied by installer) to
		all male-threaded pipe joints.			1041mm
					(41")
	•	Use the rubber grip pad provided or a strap
		wrench around pipes when tightening to
		prevent marring. Place the grip pad on the			152mm
		pipe, then put the wrench over the grip pad			(6")
		and turn the pipe with the wrench.
	•	Bottom edge of showerhead should be
		2160mm (7'-1") from floor.	NOTE: All dimensions assume standard thread
Step 3: Connect water supply				engagement. Variations in manufacturing allow
				for +/- 1/8" (3mm) per threaded joint. To find
	IMPORTANT: Do not rely on Bradley’s			the tolerance of a dimension, add the number
				of thread joints in between a dimension and
	Combination Unit to support supply			multiply it by 1/8" (3mm).
	piping.

1. Connect water supply piping to 1-1/4" BSP inlet on unit (piping supplied by installer). Provide adequate supports (supplied by

installer) for supply pipe using pipe hangers or other means.

2.Connect drain piping to 1-1/4" BSP drain outlet on unit (piping supplied by installer).

3.Hang the safety sign from the unit with the curtain hooks provided (or mount it to the wall using sign-mounting hardware supplied by installer).

Bradley Corporation • 215-163DCE Rev. Z; EN 06-532F 6/25/07 3