Bradley Smoker HN-400 Install column shower components, Connect water supply

	Barrier-Free Column Shower
Installation Instructions	HN-400

Installation Instructions for Type A HN-400 Column Shower

Step 1: Install column shower components

NOTE: Flush supply lines before making connections.

1.Remove the five bolts that secure the disposable washer to the drain and lift the disposable washer off.

2.Bolt the column shower to the drain with the five bolts (removed in procedure #1) and oval washers provided (see Figure 1).

Step 2: Connect water supply

1.Remove the two 1/4"-20 screws from the access panel on the lower body of the column shower and lift the panel off.

2.Through the access opening, connect water supplies to the shower’s 3/4" copper tubing as shown in Figure 2 (piping supplied by installer).

3.Turn on water to the shower and test for leaks and adequate water flow.

Figure 1

(5) 5/16"-18

HEX-HEAD BOLTS

160-092

(5) WASHERS 142-034

4. Replace the access panel onto the shower with 1/4"-20 screws provided.

NOTE: For column shower drains with a dome grate drain, install the two halves of the grate with the screws provided after the column installation is complete.

Figure 2

Supplies from Below/Vent Off Line

Bradley Corporation • 215-781 Rev. D; EN 03-310 12-16-2003 3