| |
Installation Instructions |
Installation Instructions continued . . .
Step 2: Fill tank and pressurize
1.If the tank is pressurized, relieve the tank pressure by pulling up on the relief tank tab in the center of the cover until the pressure gauge reads “0.”
IMPORTANT: DO NOT open the cover until the pressure gauge reads “0”!
2.Open the tank by pulling up on the wire handle located on top of the Quicklock cover. Push down, rotate and remove. Fill the container with 7 gallons of potable water. Replace the cover.
3.Pressurize the tank to 95 PSI by applying air pressure to the valve located beneath the pressure gauge.
NOTE: Relief valve is designed to automatically vent at
Step 3: Flush tank
1.Discharge the water through the eye wash for at least five minutes to flush the system.
2.Refill the tank and pressurize as explained in Step 2 outlined above.
NOTE: Let unit stand for one hour. If there is a noticeable pressure drop, repressurize back to 95 PSI and let stand for one hour. If problems persist, consult the Troubleshooting guide found on page 5.
NOTE: This unit will provide at least 15 minutes of cleansing action. Take the injured person immediately to a normal emergency station for additional cleansing and treatment.
3. FOR OPTIONAL HEATER JACKET: Plug the jacket’s electrical cord into an electric outlet.
4 | Bradley Corporation • |
