Installation Aerada 1000/1100 Series
Bradley Corporation • 215-1628 Rev. A; EN 08-201 5/21/08 7
9 Mount mixer handle (only for faucets with external mixer)
Result: The faucet is now mounted.
A - Setting Cleaning Mode
Setting the cleaning mode will make the faucet inactive for 90 seconds.
1 Enable “Manual Setting” Mode
> See “Enabling Manual Setting Mode” section
2 Fully cover sensor with hand, until water fl ow stops. (This takes 5 seconds.)
3 Remove hand.
Result: The Cleaning Mode is now active. For the next 90 seconds, the faucet
will be inactive.
B - Setting Normal Mode
Setting the normal mode will allow the faucet to activate only when it senses a
hand presence.
1 Enable “Manual Setting” Mode
> See “Enabling Manual Setting Mode” section
2 Fully cover sensor with hand. Water fl ow stops after 5 seconds - Continue to
hold on for one (1) additional water pulse.
3 Remove hand.
Result: Normal Mode is now activated.
C - Setting Metering Mode (10 seconds)
Setting the metering mode will allow the faucet to activate for a full 10 seconds
after if senses a hand presence.
1 Enable “Manual Setting” Mode
> See “Enabling Manual Setting Mode” section
2 Fully cover sensor with hand. Water fl ow stops after 5 seconds - Continue to
hold on for another two (2) additional water pulses.
3 Remove hand.
Result: Metering Mode is now activated for 10 seconds.