Brady Brady Worldwide Identification Solutions, DSP-5 Set-Up Instructions, Adjustments, Incorrect

SET-UP INSTRUCTIONS

Using 5/32" (4mm) hex wrench, adjust reel holder arm to vertical.

Place the label roll on the 1" (25mm) reel hanger bar.

*If roll has 3" (76.2mm) core, use plastic spool*

Slide “O” ring onto reel hanger bar to hold roll against reel holder arm to ensure it is held straight.

(Hex wrench, O-ring and spool included.)

Thread the liner under the guide rod, between the hold down brush and the strip plate, then back under the strip plate. Lay the liner across the slot in the take-up hub. Slide the lock rod into the slot to secure the liner. Align shaft collar on guide rod with edge of liner to keep material feeding straight.

Reel Holder Arm

Hold Down Brush Guide Rod

Lock Rod

Reel Hanger Bar

Strip Plate

Photosensor Take-up Hub

ADJUSTMENTS

Hold Down Brush:

Using the upper thumbscrew on the side of the machine, adjust the hold down brush for tensioning.

For best results, labels should be pressed firmly against the strip plate. If labels are held too tightly, they will cause excessive drag on the motor.

Photosensor:

The photosensor can be adjusted in any direction to accommodate virtually any label. Loosening the lower thumbscrew allows the photosensor to swivel and sets the overhang distance of the label over the strip plate. When the label is being fed the correct distance, tighten the lower thumbscrew.

Loosen the two screws on the front of the sensor holder to align the photosensor with the center of the label. If there are two or more labels across, align the photosensor with the last label to be removed. When these two screws are tightened, the machine is set.

Positioning of Photosensor

Incorrect

Sensor sees beyond label	Sensor sees strip plate
- Will not stop	- Will not feed

Correct

Sensor sees front edge of label

4 5