Braun 4130 manual Safety features, Using your handblender, Using your chopper attachment

Switch release	Charging or operation
button (2) pressed	conditions
down
Green	Battery is fully charged
Red/green flashing	Charge sufficient for at
	least one usage
Red	Battery is discharged
Red	Overheating protection
	active (go to Safety
	features Α Overheat
	protection)

Safety features

Switching on the appliance / Switch lock

The appliance has a switch lock. To safely switch it on, follow these points:

1First press the switch release button (2) with your thumb and hold.

2Then press the On switch (3). During operation, you can stop pressing the switch release button.

•If the On switch (3) is not pressed within

5 seconds, the appliance cannot be switched on. The pilot light goes off.

•In order to switch the appliance on, start again with step 1.

Overheat protection

When the overheat protection feature is active, the appliance turns off and the pilot light shines permanently red.

Reason	Trouble shooting
Blade is blocked	1. Remove motor part
	2. Remove the food/
	blockage
	3. Place the motor part
	into the charging unit
	(connected to the mains)
	for at least 1 second
	4. Processing can be
	continued
Appliance is	Follow points 1.-4.
overheated	If the pilot light still shines
	red when switching on the
	appliance, place the motor
	part back into the charging
	unit and let it cool down
	for ca. 1 hour. During this
	time, the pilot light flashes
	green.

Auto Off

For safety reasons the appliance turns off after

4 minutes of permanent usage. The appliance can be turned directly on again.

Using your handblender

The handblender is perfectly suited for preparing dips, sauces, soups, mayonnaise and baby food as well as for mixing drinks and milkshakes.

a)Remove knife protection at the bottom of the blender shaft by removing the adhesive tape. Insert the motor part (4) into the blender shaft (6) until it locks.

b)Introduce the handblender vertically into the vessel, keep the switch release (2) pressed down, then press the On switch (3).

c)To remove the blender shaft from the motor part, press push buttons (5).

When operating the handblender in hot liquids do not immerse the blender shaft into – or remove it from the liquid while the appliance is switched on.

Recipe example: Mayonnaise200–250 ml oil,

1 egg (yolk and white),

1 tbsp. lemon juice or vinegar, salt and pepper to taste

Put all ingredients into the beaker according to the a.m. order. Introduce the handblender to the base of the beaker. After switching on, keep the handblender in this position until the oil emulsifies. Then, without switching off, slowly move it up and down until the mayonnaise is well combined.

Using your chopper attachment

The chopper is perfectly suited for chopping meat, cheese, onions, herbs, garlic, carrots, walnuts, hazelnuts, almonds etc.

N.B.: Do not chop extremely hard food, such as ice cubes, nutmeg, coffee beans or grains.

Before chopping ...

•pre-cut meat, cheese, onions, garlic, carrots (s. table p. 5)

•remove stems from herbs, shell nuts,

•remove bones, tendons and gristle from meet.

1.Carefully remove the plastic cover from the blade (11b). Caution: The blade is very sharp! Always hold it by the upper plastic part. Place the blade on the centre pin of the chopper bowl (11c). Press down the blade until it locks. Always place the chopper bowl on the anti-slip base (11d).

8