Braun 5525 manual Shaving Longhair trimmer Switching the shaver off, Purchasing spare parts

7 thoroughly with the

Shaving

Longhair trimmer 5

Switching the shaver off

•Take off the foil protection cap 9.

•For shaving, push the switch 4 to setting «1».

•Hold the shaver at right angles (90°) to the skin.

•Stretch the skin with your free hand.

•Guide the shaver smoothly against the direction of beard growth, applying only gentle pressure.

The pivoting cutting system (twin foil H and integrated longhair cutter h follows the contours of your face automatically.

While shaving difficult parts of your face (e. g. under the nose or at the hairline), push switch 4 to setting «2», to lock the pivoting head at an angle.

To activate the longhair trimmer, move the switch 4 to setting «3». The longhair trimmer moves upwards and allows easy and exact trimming of the side burns.

Move the switch 4 back to setting «0».

Important: After every shave, put the foil protection cap 9 on the pivoting head.

Switch the shaver off.

After each shave take off the triple shaving frame 8. Press the button j to release the triple shaving frame and pull it off.

Tap out slightly the triple shaving frame. Do not clean the twin foil H with the brush.

Clean the duo cutterblock brush.

Move the duo cutterblock crosswise and take it off. Brush out the entire pivoting head area, including the cutterblock base 6. After cleaning place the duo cutterblock back into the cutterblock base 6 and replace the triple shaving frame 8 until it clicks into place.

Approximately every four weeks clean the duo cutterblock 7 with Braun cleaning agents.

After every cleaning replace the foil protection cap 9.

The triple shaving frame and duo cutterblock are precision parts that will wear out over time. To maintain optimal shaving performance you should replace these parts when worn. This will ensure that you continue to get the close, comfortable shave you expect from your Braun shaver.

Important: Buy only original Braun spare parts, especially when replacing the cord or the triple shaving frame 8. When replacing the triple shaving

frame look for the brand. Only this way you will obtain a perfect shave.

Triple shaving frame 8: Remove as described under «Cleaning and maintenance». Set the new triple shaving frame on the pivoting head until it clicks into place. Handle with care.

Duo-cutterblock 7: Take as described under «Cleaning and maintenance». Place the new duo cutterblock into the cutterblock base 6 until it clicks into place.

Cleaning and maintenance

Purchasing spare parts

6

7