English
Batteries
This appliance operates on two 1.5 volt batteries. For best performance, use alkaline batteries (type LR 6, AM 3, MN 1500 or size AA alkaline, e.g. Duracell). These batteries provide a shaving capacity of approx. 60 minutes.
Slide the battery 8 cover in the direction indicated by the arrow, then open. Insert batteries 7 with the poles in the direction marked. Close the battery cover and slide it back to start position.
Note: Never leave batteries in the shaver for long periods of time when the shaver is not in use (danger of leakage). Take expired batteries out of the shaver immediately.
Used batteries should not be thrown away with the house hold waste. Please dispose of them at special collection points or return them to your retailer or authorized service centre.
Shaving
Turn the twisting protective cap 1 (a) until it clicks in place as shown (b). This will extend your shaver for better handling and allow operation of the on/off switch.
To switch the shaver on, push the on/off switch
2upward to the « on » position.
Hold the shaver at right angles to your skin (c) and shave against the direction of beard growth.
Tip: Stretch the skin slightly and only apply gentle pressure.
Cleaning and maintenance
To experience the best possible shave you should clean the shaver after each use:
1.Press foil frame release buttons 5 and remove the foil frame 4 (e).
2.Tap the foil frame gently against a flat surface, then clean the cutterblock 3 thoroughly with the brush 6 as shown (f).
3.Place the foil frame over the cutterblock and gently push down until it clicks back into position.
Approximately every four weeks clean the cutterblock 3 with Braun cleaning products.
After cleaning, turn the twisting protective cap
1180° to cover the shaving head. In this position, the on/off switch is automatically locked to avoid accidental operation of the shaver (e. g. when travelling).
