Braun MD 9000 manual Use, Single and multiple jet, After use, Cleaning, Dental centre

8out of the magnetic holder (b), hold it over the washbasin and turn the unit on.

Use

Fill the water container 1 with water again and add mouthwash if desired. Place it firmly onto the motor part (c).

Attach one of the jets 4 to the handle 8 until it clicks in place (d). Turn the jet to the direction desired.

Select the water pressure with the water impact control 5; it is best to start with the gentlest pressure (setting 2), espe- cially if your gums tend to bleed or if children are using the oral irrigator.

To remove resistant food particles, you may use the press button 6 for maximum water pressure (corresponding to setting 8 on the water impact control 5).

Bend over the washbasin and guide the jet to your teeth. Then turn the unit on with switch 7. The water jet impulses will start in a few seconds. Keep your mouth slightly open to allow the water to run into the washbasin.

Single and multiple jet

The oral irrigator jet removes remaining food particles from between your teeth while also massaging your gums. There are two different jet functions:

Single jet: Point of the jet in position (e) to clean the teeth and the spaces between the teeth and to remove resistant food particles (materia alba).

Multiple jet: Point of the jet in position (f) to massage the gums and keep them healthy.

Begin with the single jet. Guide the water to the teeth and especially to the spaces between the teeth. Then massage the gums with the multiple jet.

The jet can easily be switched from one function to the other. Turn off the oral irrigator with switch 7 (to avoid uncon- trolled water spraying) and press the point of the jet in or out. Then turn the unit on again with switch 7.

After use

Do not turn off the unit unless the water container is entirely empty. Bacteria could otherwise collect in the remaining water if the unit is not used for some time.

After use, return the handle 8 to the magnetic holder (b). The attachable jets

4can be stored in the removable com- partment 3.

Cleaning

Clean the motor part 2 with a damp cloth. Wipe the handle 8 dry. The water container 1 and the removable com- partment for the jets can be washed in the dishwasher.

Dental centre

Your Braun Oral-B Plak Control oral irrigator can easily be turned into a complete dental centre: The connections

jon the side of the motor part 2 allow you to connect a Braun Oral-B Plak Control plaque remover. The plaque remover and the oral irrigator are then operated as a dental centre using the cord of the irrigator.

The charging unit for the plaque remover (type 4723) is available at your dealer.

Subject to change without notice.

This product conforms to the EMC- Requirements as laid down by the Countil Directive 89/336/EEC).

8