Braun SIP 3.0.2 Shaver indicator lights, Quick cleaning, Thorough manual cleaning

off

1

2

off

1

old new

empty cha

8781

cha

empty

8781

Quick cleaning

Press the foil release buttons (12) to lift the shaver foil (do not remove the foil completely). Switch on the shaver for approx. 5–10 seconds so that the shaved stubbles can fall out.

Thorough manual cleaning

Manual cleaning is recommended only when the Clean&Renew™ station is not available, e.g. when travel- ling. Never use water to clean the shaver.

Remove the shaver foil and tap it out on a flat surface. Using the brush, clean the cutter block and the inner area of the pivoting head. If you do not use the Clean&Renew™ station for a longer period of time, you should apply a drop of light machine oil onto the shaver foil.

Replacing the cartridge

After having pressed the lift button (4) to open the housing, wait for a few seconds before removing the used cartridge.

Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution.

Cleaning shaver and Clean&Renew™ housing

Clean the housing of shaver and Clean&Renew™ station from time to time using a damp cloth, paying special attention to the opening of the station where the shaver rests.

The shaver indicator lights

Pilot light (18): the shaver is connected to an electrical outlet.

The red low-charge light (17) flashes when the battery capacity has dropped below 20%, provided the shaver is switched on. The remaining capacity will then be sufficient for 2 to 3 shaves.

10