Bravetti BB301 Care And Cleaning Of Your Blender, Dishwasher, By An Authorized Service Facility

CARE AND CLEANING OF YOUR BLENDER

Blender container parts are corrosion resistant, sanitary and easily cleaned. Before first use and after every use, separate container parts and clean thoroughly in warm, soapy water, then rinse and dry well. DO NOT WASH ANY PARTS IN AN AUTOMATIC

DISHWASHER.

Periodically check all parts before re-assembly. If the processing blades are stuck or difficult to turn, DO NOT USE BLENDER. Check by carefully turning the blades in a counter clockwise direction (opposite edges are sharp). Blades should turn freely. If the glass container is chipped or cracked DO NOT USE BLENDER. Further use could result in the container breaking during use. Use only Bravetti recommended replacement parts available at an authorized service facility or the factory. USE OF

DAMAGED OR NON-RECOMMENDED PARTS COULD RESULT IN SEVERE PERSONAL INJURY AND/OR DAMAGE TO THE BLENDER.

NEVER IMMERSE THE MOTOR BASE IN WATER. The housing can be cleaned with a damp cloth (unplug first). The motor is permanently lubricated and does not require any additional lubrication. ANY SERVICING SHOULD BE PERFORMED

BY AN AUTHORIZED SERVICE FACILITY.

CARE AND CLEANING STEPS

1.Push the OFF button and unplug the appliance.

2.Grasp container handle and lift container from the blender motor base. Rinse with water to remove any large food particles that may have accumulated in the container.

3.Reposition the container into the blender motor base.

4.Add 1 1/2 cups warm, soapy water to the container and cover with the lid assembly.

5.Push one of the low settings for a few seconds.

6.Touch the OFF position and unplug the appliance.

7.Grasp container handle and lift container off of the blender motor base. Remove lid and assembly and rinse container with water. Repeat steps 1-7 as necessary.

8.Unscrew collar from container and remove cutting assembly.

CAUTION: BLADES ARE SHARP. HANDLE CAREFULLY.

CAUTION: NEVER PLACE BLENDER MOTOR BASE OF APPLIANCE IN WATER OR OTHER LIQUIDS.

1.Immediately after each use, disassemble lid and cutting assembly. Carefully wash all parts in warm soapy water. Rinse and dry thoroughly. Do not wash parts in dishwasher.

2.Do not use a harsh abrasive on any part of the blender.

3.Clean the exterior of blender motor base with a soft damp cloth and dry.

4.Reassemble cutting assembly onto container. Place onto blender motor base with lid assembly. Spin dry on HIGH for 10 seconds.

Any servicing requiring disassembly other than the above cleaning must be performed by an authorized service center. Failure to follow this instruction may result in a fire, electric shock or injury to persons.

7 8