Operating Instructions
Getting to Know Your Stick Blender
•Do not operate continuously for more than 1 minute.
•If pieces of unprocessed food remain, or if there are any lumps, continue pureeing the food, however, mash the food pieces or lumps by slightly raising and then lowering the stick blender over those pieces.
Multi-Mixer Assembly
CAUTION: Ensure that the appliance is unplugged from the electrical power source before changing attachments. Do not immerse the mixer gear box in water.
1.To attach the mixer gear box to the power pack, line up arrow on the power pack and mixer gear box.
2.Push power pack onto mixer gear box until seated.
3.While grasping mixer gear box rotate it 90º clockwise until the arrow on the power pack aligns with the “Square” on the mixer gear box.
4.To disassemble mixer gear box and power pack rotate mixer gear box 90º counterclockwise.
Attaching the Attachments to the Gear Box
CAUTION: Ensure that the appliance is unplugged from the electrical power source before changing attachments. Do not immerse the gear box in water.
Select the desired attachment, either the dough hooks, wire beaters or whisk and assemble to gear box as noted below:
Note: When inserting dough hooks or beater attachments, make sure to insert the piece with the ring on the shaft into the larger opening of the gear box.
Dough Hooks (x2):
For use with light dough ONLY.
•Insert stem end of dough hooks (one at a time) into opening in base of gear box.
•Rotate slightly while pressing gently until dough hook “clicks” into place.
•Repeat for second dough hook.
•Ensure that dough hooks are well seated in mixer gear box.
Wire Beaters (2):
Follow same installation procedure as above.
Wire Whisk:
This attachment is used for beating air into mixtures such as egg whites, yolks or creams.
•To install, place stem of wire whisk into either of the openings in the mixer gear box.
•Rotate wire whisk while pushing gently until wire whisk “clicks” into place.
•Ensure that wire whisk is well seated in gear box.
1.After attaching the desired accessory into the gear box, plug the mixer into power source.
2.Hold the power pack with one hand and press and hold the On/Off switch with your index finger.
3.Ensure that there are no obstructions and that the accessories are moving freely in the mixing container.
4.When finished using the unit, unplug the unit before removing the accessories.
1. | 350 Watt Power Pack | 8. | Wire Whisk |
2. | On/Off Switch | 9. | Glass Beaker |
3. | Variable Speed Control | 10. | Wall Bracket |
4. | Gear Box | 11. | Wall mounting hardware |
5. | Dough Hooks (x2) |
| (not illustrated) |
6.Stick Blender
7.Wire Beaters (x2)
*Illustrations may differ from actual product.
Technical Specifications
Voltage: | 120V., 60Hz. |
Power: | 350 Watts |
5
2
