Pressure Washer
4.Insert “L” bolt through hole on left side of handle (viewing from rear of unit) and attach plastic knob. Tighten knob by hand (Figure 3).
Figure 3 — Secure Handle |
5.Insert carriage bolt through right side hole from outside of unit and attach plastic knob from inside of unit (viewing from rear of unit).Tighten by hand (Figure 3).
6.Insert “J” hook into second from left slot in accessory tray (Figure 4).
Figure 4 — Install “J” Hook on Accessory Tray
7.Pinch chemical hose and slide it into metal clip as shown in Figure 5.
Figure 5 — Slide Chemical Hose into Metal Clip
8.Tilt unit up by handle and attach metal clip to rib on center underside of accessory tray (Figure 6). Slide chemical hose through metal clip so that it is tight but not kinked.
Figure 6 — Slide Metal Clip onto Accessory Tray Flange
6
