ASSEMBLY
Pressure Washer
To attach handle with accessory tray (Models 01805 and 01806):
IMPORTANT: Read entire owner’s manual before you attempt to assemble or operate your new pressure washer.
Remove Pressure Washer From Carton
1.Remove the parts bag, accessories, and inserts included with pressure washer.
2.Slice two corners at the end of carton from top to bottom so the panel can be folded down flat.
3.Remove pressure washer from carton.
PREPARING PRESSURE WASHER FOR USE
If you have any problems with the assembly of your pressure washer or if parts are missing or damaged, call the pressure washer helpline at
Perform these tasks to prepare unit for operation:
•Attach the handle to the main unit.
•Add oil to the engine.
•Add fuel to the fuel tank.
•Connect the high pressure hose to the spray gun and the pump.
•Connect the water supply to the pump.
•Connect nozzle extension to spray gun.
•Select and install desired nozzle (if applicable).
Attach Handle to Unit
This manual describes assembly and use of three models (01805, 01806 and 01936). Please see the appropriate section for the handle instruction specific to your model.
NOTE: All assembly operations given in this section will be described from the perspective of assembling the pressure washer from the rear.
1.Slide plastic accessory tray onto handle and align holes in accessory tray with holes on handle (Figure 1).
Figure 1 — Attach Accessory Tray
2.Secure tray to handle with self tapping screws using a #2 phillips screwdriver. Ensure screws are tight but not crushing the plastic accessory tray.
3.Place handle assembly onto handle supports connected to main unit. Make sure holes in handle align with holes on handle supports (Figure 2).
Figure 2 — Attach Handle to Base
Handle
Align Holes 
Handle
Supports
NOTE: It may be necessary to move handle supports from side to side in order to align handle so it will slide over handle supports.
5
