Pressure Washer
5.Apply detergent to a dry surface, starting at lower portion of area to be washed and work upward, using long, even, overlapping strokes. DO NOT allow detergent to dry on (prevents streaking).
6.Allow detergent to soak in between
Pressure Washer Rinsing
WARNING! Be extremely careful if you must use the pressure washer from a ladder, scaffolding or any other relatively unstable location.When you press the trigger, the recoil from the initial spray can be very strong.The high pressure spray could cause you to fall if you are too close to the cleaning surface.
After you have applied detergent, scour the surface with the high pressure water stream and then rinse it clean, as follows:
1.Apply safety latch to spray gun.
2.Slide nozzle backwards or insert high pressure quick connect spray tip to place pressure washer in high pressure mode. Chemical will not flow when in high pressure mode.
3.Keep spray gun a safe distance from spray area.
4.Disengage safety latch on spray gun.
CAUTION! Firmly grasp spray gun with both hands when using high pressure spray to avoid injury if gun kicks back.
5.Expand spray pattern or select white 40° quick connect spray tip for a more gentle rinsing action. Start at top of area to be rinsed, working down with same action as for cleaning.
CAUTION! Test a small area of the surface to be cleaned. Make sure there is no damage caused by the high pressure spray.
Cleaning Detergent Siphoning Tube
1.Place chemical injection siphon/filter in bucket full of clean water.
2.Attach black low pressure spray tip or slide adjustable nozzle forward to low pressure mode.
3.Flush for
Automatic Cool Down System (Thermal Relief)
If you run the engine on your pressure washer for
discharging the warm water onto the ground.
11
