SpeedClean™ 2800 PSI Pressure Washer
PREPARING THE UNIT FOR STORAGE
Water should not remain in the unit for long periods of time. Sediments or minerals can deposit on pump parts and “freeze” pump action. If you do not plan to use the pressure washer for more than 30 days, follow this procedure:
1.Flush detergent siphoning tube by placing filter into a pail of clean water while running pressure washer in low pressure mode. Flush for one to two minutes.
2.Shut off engine and let it cool, then remove high pressure and garden hoses. Disconnect spark plug wire from spark plug.
3.Empty pump of liquids by pulling engine recoil handle about 6 times.This should remove most liquid in pump.
4.Use pump saver to prevent corrosion build up and freezing of pump.
5.Store unit in a clean, dry area.
Protecting the Pump
To protect the pump from damage caused by mineral deposits or freezing, use PumpSaver to treat pump.This prevents freeze damage and lubricates pistons and seals.
NOTE: PumpSaver is available as an optional accessory. It is not included with the pressure washer. Contact the nearest authorized service center to purchase PumpSaver.
To use PumpSaver, make sure the pressure washer is turned off and disconnected from supply water. Read and follow all instructions and warnings given on the PumpSaver container.
CAUTION
You must protect your unit from freezing temperatures.
•Failure to do so will permanently damage your pump and render your unit inoperable.
•Freeze damage is not covered under warranty.
CAUTION
Read and follow all cautions and warnings on the PumpSaver can label.
• Always wear eye protection when using PumpSaver.
CAUTION
PumpSaver will drip from pump after treatment and will stain wood and concrete.
• Protect surfaces from dripping PumpSaver.
NOTE: If PumpSaver is not available, draw RV antifreeze
STORING THE ENGINE
See the engine owner’s manual for instructions on how to properly prepare the engine for storage.
16
