SpeedClean™ 2800 PSI Pressure Washer
2.Insert carriage bolts through holes from outside of the unit and attach a plastic knob from inside of unit (Figure 2).Tighten by hand.
Figure 2 — Secure Handle
3.Insert one “L” hook through hole just under billboard on left side of handle (viewing from rear of unit). Hold hook in place and attach a plastic knob from inside of unit (Figure 3).Tighten by hand.
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
CAUTION
Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.
•Refer to engine manual for oil and fuel fill information.
•Damage to equipment resulting from failure to follow this instruction will void warranty.
•Refer to engine owner’s manual and follow oil and fuel recommendations and instructions.
NOTE: Check oil often during engine
Figure 3 — Attach “L” Hooks to Handle
Spray Gun
Hook
Hose Hook
4.Insert other “L” hook through hole just above billboard on right side of handle (viewing from rear of unit). Hold hook in place and attach a plastic knob from inside of unit (Figure 3).Tighten by hand.
Connect Hose and Water Supply to Pump
IMPORTANT: To avoid pump damage, you must assemble the nozzle extension to the spray gun and attach all hoses before you start the engine.
1.Uncoil high pressure hose and attach one end of hose to base of spray gun (Figure 4).Tighten by hand.
Figure 4 — Connect High Pressure Hose to Spray Gun
7
