Briggs & Stratton 020261-0 manual Attach Detergent Siphon Hose to Pump, Add Engine Oil and Fuel

SpeedClean™ 2200 PSI Pressure Washer

2.Insert carriage bolts through holes from outside of unit and attach plastic knob from inside of unit (Figure 2).Tighten by hand.

Figure 2 — Secure Handle

3.Place cleaning tank over holes on handle (viewing from front of unit). Push the tree clips into the holes until they sit flat against the cleaning tank (Figure 3).

Figure 3 — Attach Cleaning Tank to Handle

Attach Detergent Siphon Hose to Pump

Attach detergent siphon hose to barbed hose fitting on pump (Figure 5).

Figure 5 — Attach Detergent Siphon Hose to Pump

3.Insert one “L” hook through hole just above cleaning tank on left side of handle (viewing from front of unit). Hold hook in place and attach plastic knob from inside of unit (Figure 4).Tighten by hand.

Figure 4 — Attach “L” Hooks to Handle

Spray Gun

Hook

Hose Hook

Add Engine Oil and Fuel

• Place pressure washer on a level surface.

CAUTION

Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.

•Refer to engine operator’s manual for oil and fuel fill information.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

•Refer to engine operator’s manual and follow oil and fuel recommendations and instructions.

NOTE: Check oil often during engine break–in. Refer to engine operator’s manual for recommendations.

4.Insert other “L” hook through hole just above cleaning tank on right side of handle (viewing from front of unit). Hold hook in place and attach plastic knob from inside of unit (Figure 4).Tighten by hand.

8