Briggs & Stratton 030209-1 Assembly, Unpacking the Generator, Carton Contents, Install Wheel Kit

5500W Portable Generator

ASSEMBLY

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

•Engine operator’s manual

•Wheel kit

If any parts are missing or damaged, call the generator helpline at 1-800-743-4115.

If you have any problems with the assembly of your generator, please call the generator helpline at

1-800-743-4115. If calling for assistance, please have the model, revision, and serial number from the data tag available. See “Know Your Generator” for data tag location.

Unpacking the Generator

1.Set the carton on a rigid flat surface.

2.Remove everything from carton except generator.

3.Open carton completely by cutting each corner from top to bottom.

4.Leave generator on carton to install wheel kit.

Carton Contents

Check all contents against those listed below:

•Main unit

•Engine oil

•Operator’s manual

Install Wheel Kit

The wheel kit is designed to greatly improve the portability of your generator.

NOTE: Wheel kit is not intended for over-the-road use.

You will need the following tools to install this wheel kit:

•1/2" or 13mm socket wrench

•1/2" or 13mm open end wrench

•Pliers

•Safety glasses

Refer to Figure 1 and install the wheel kit as follows:

1.Tip generator so that engine end is up.

2.Slide axle through both mounting brackets.

3.Slide a wheel over the axle.

4.Place a washer on axle and then place an e-ring in axle groove.

5.Install e-ring with pliers, squeezing from top of e-ring to bottom of axle.

Figure 1 — Install Wheel Kit

Capscrew
Nut
Handle		Wheel
		Washer
	Axle
Mounting Leg	Capscrew
		E-Ring
	Nut
	6