Briggs & Stratton 030210-2 manual Install Wheel Kit, E-rings can cause eye injury

8000W Portable Generator

Install Wheel Kit

The wheel kit is designed to greatly improve the portability of your generator.

NOTE: Wheel kit is not intended for over-the-road use. You will need the following tools to install this wheel kit:

•1/2" or 13mm socket wrench

•1/2" or 13mm open end wrench

•Needle-nose pliers

•Safety glasses

Refer to Figure 2 and install the wheel kit as follows:

1.Tip generator so that engine end is up.

2.Slide axle through both mounting brackets.

3.Slide a wheel over the axle.

NOTE: Be sure to install both wheels with the air pressure valve on the outboard side.

4.Place a washer on axle and then place an e-ring in axle groove.

5.Install e-ring with pliers, squeezing from top of e-ring to bottom of axle.

CAUTION

E-rings can cause eye injury.

E-rings can spring back and become airborne when installing or removing.

• Always wear eye protection when installing/removing e-rings.

6.Repeat step 3 thru 5 to secure second wheel.

7.Tip generator so that engine side is down.

8.Attach the vibration mounts to the support leg with 1/4-20 x 1” capscrews and 1/4-20 lock nuts.

9.Attach support leg with M8 x 20 mm cap screws and M8 lock nuts.

10.Return generator to normal operating position (resting on wheels and support leg).

11.Check each fastener to ensure it is secure and the tires are inflated between 15-40 PSI.

Figure 2 — Install Wheel Kit

	Wheel
	Flat Washer
	Axle
Hex Nut
Support Leg	Cap Screw
	E-Ring
Vibration Mount
Cap Screw	Hex Nut
	7