Briggs & Stratton 030248-0 manual Assembly, Unpack Generator, Install Wheel Kit, Shipment Contents

Assembly

Read entire operator’s manual before you attempt to assemble or operate your new generator.

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended fuel and oil.

If you have any problems with the assembly of your generator, please call the generator helpline at 1-800-743-4115. If calling for assistance, please have the model, revision, and serial number from the data tag available. See Generator Controls and Features for data tag location.

Unpack Generator

1.Set the carton on a rigid, flat surface.

2.Remove everything from carton except generator.

3.Open carton completely by cutting each corner from top to bottom.

4.Leave generator on carton to install wheel kit.

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use.

You will need the following tools to install these components:

•2 - 13mm open end wrenches

•15/16" open end wrench

Install the wheel kit as follows:

1. Place bottom of generator cradle on a flat surface.

2.Place axle stud (A) through wheel retainer on cradle frame.

3.Use 15/16” wrench to secure axle stud to frame with 5/8-18 jam nut (B).

4.Install other axle stud in same manner.

5.Tip unit and install wheel (C). Place flat washer (D) over axle stud.

NOTE: Be sure to install wheel with raised hub inboard.

6.Retain wheel on axle stud with retaining pin (E). Install other wheel on remaining axle stud the same way.

Shipment Contents

The generator is supplied with:

•Engine oil bottle

•Operator’s manual

•Wheel kit

7.Attach support leg (F) using two 13mm wrenches with 20mm cap screws (G) and lock nuts (H).

8.Center lifting handle (J) on generator end of cradle. Attach handle using two 13mm wrenches with 45mm capscrews (K) and hex nuts (L).

K
	Typical Generator Shown
L	B
J	D
	A
	G
	C
F	E
	H

5