Installation

Unpacking

Delivery Inspection

After removing the carton, carefully inspect the transfer switch components for any damage that may have occurred during shipment.

IMPORTANT: If loss or damage is noted at time of delivery, have the person(s) making delivery note all damage on the freight bill and affix his signature under the consignor's memo of loss or damage. If loss or damage is noted after delivery, contact the carrier for claim procedures. Missing or damaged parts are not warranted.

Shipment Contents

Automatic Power Transfer Switch

Installation and Operator’s Manual

Current Transformers

Mounting Guidelines

The Automatic Transfer Switch is enclosed in a NEMA Type 3R enclosure suitable for indoor/outdoor use. Guidelines for mounting the Automatic Transfer Switch include:

Install the switch on a firm, sturdy supporting structure.

The switch must be installed with minimum NEMA 3R hardware for conduit connections.

To prevent switch contact distortion, level and plumb the enclosure. This can be done by placing washers between the switch enclosure and the mounting surface.

NEVER install the switch where any corrosive substance might drip onto the enclosure.

Protect the switch at all times against excessive moisture, dust, dirt, lint, construction grit and corrosive vapors.

A typical installation of the Automatic Power Transfer Switch is depicted below. An alternative installation of the Automatic Power Transfer Switch is also depicted below. It is best if the transfer switch is mounted near the utility meter, either inside or outside. Discuss layout suggestions/ changes with the owner before beginning the system installation process.

Typical

 

Watt -

— — — — — — Control Wiring

Hourmeter

Service

Disconnect

Contactor

 

Main

 

Transfer

 

 

Breaker

 

Switch

Generator

Hot Water

Panel

 

 

 

 

 

Heater

 

 

 

 

 

 

 

 

Branch Circuits

Air

Conditioner

Disconnect Switch

Alternate

 

Watt -

— — — — — — Control Wiring

Hourmeter

Contactor

Branch

Circuits

 

 

Transfer

Main

 

Emergency

Switch

Breaker

Hot Water

Load Center

 

Panel

 

 

 

Heater

 

 

Generator

 

 

 

 

 

 

Disconnect Switch

 

Emergency

 

Air

 

 

 

 

Branch Circuits

 

Conditioner

6

BRIGGSandSTRATTON.COM

Page 6
Image 6
Briggs & Stratton 071019 manual Installation, Unpacking, Mounting Guidelines