Installation Instructions
Gear Case Kit
Part No. 1687227 & 1687228
For 2004 Simplicity 860EI Intermediate Snowthrowers
1694433, 1694434
Kit Contents:
| Ref | Part No. | Qty. | Description |
4 | 1 | 1721684 | 1 | GEAR CASE, RH |
3 | 2 | 7090052 | 6 | WASHER, 1/4” SPLIT LOCK |
3 | 7092129 | 12 | WASHER, FLAT, .268 x .591 | |
| 4 | 7091576 | 6 | NUT, HEX, |
| 5 | 7092125 | 6 | SCREW, HEX, |
| 6 | 1721676 | 1 | GASKET, GEAR CASE |
2 | 7 | 1721685 | 1 | GEAR CASE, LH |
7 | 8 | 960625 | 1 | FITTING - PIPE PLUG |
| 8 |
|
|
|
| 6 |
|
|
|
| 1 |
|
|
|
| 3 |
|
|
|
| 5 |
|
|
|
Figure 1. Contents
This kit is to service intermediate snowthrowers.
INSTALLATION
Disassemble Housing
WARNING
Before beginning any service work turn off the ignition, and disconnect the spark plug wire(s).
1.Remove the washers and retaining rings (D, Figure 2) from both ends of the auger shaft. Remove the bearings (C).
2.Remove the hardware securing both side covers (A), and remove the side covers.
A |
D |
B |
C |
Figure 2. Disassemble Housing
A.Side Cover
B.Housing
C.Bearing
D.Washers & Retaining Ring
1
