Cat 5e (or better) UTP
Connecting Power to the Local and Remote Extenders
1.Plug the supplied 5V, 3A power adapter into a suitable AC outlet near the local extender.
2.Connect the power adapter to the local extender.
3.Plug the supplied 5V, 3A power adapter into a suitable AC outlet near the remote extender.
4.Connect the power adapter to the remote extender.
Connecting a USB Device
1.Install any software required to operate the USB device(s). Refer to the documentation provided for your USB device(s).
2.Connect the USB device to the device port on the remote extender.
3.Check that the USB device is detected and installed properly in the operating system.
Verifying Installation
1.On the local and remote extender units, check that the Power, Link, USB, and Video LEDs are on. If the Link LED is off, then the cabling between the local and remote extenders is not installed properly or is defective.
Instruction Manual
8
