Briggs & Stratton 1695195 Installation Instructions, Initial Assembly, Sub-Frame Hitch

Installation Instructions Sub-Frame Hitch

NOTE: Please read through these instructions and the instructions of any other attachments before beginning installation.

WARNING

Before beginning any service work turn off the PTO, set the parking brake, turn off the ignition, and disconnect the spark plug wire(s).

INITIAL ASSEMBLY

Assemble Hitch

1.Attach the support clamp (C, Figure 2) and hook assembly (B) to the hitch. Secure with four 5/16-18 x 1 carriage bolts (A), washers (D), lockwashers (E), and nuts (F). Do not tighten the hardware at this time.

	F	B
Broadmoor /
	E	C
1600 / 2600
Series	D
		A
Conquest / 1700 /		B
		A
2700 &
Prestige / 1800 /		C
2800 Series
		D
		E
		F

Figure 2. Install Support Clamp
A. 5/16-18 x 1 Carriage Bolt	D. 11/32 Washer
B. Hook Assembly	E. 5/16 Lockwasher
C. Support Clamp	F. 5/16-18 Nut

Change Pulley & Belt - Two-Stage Blower Only

1.If using this hitch with a two-stage snowthrower, the front idler pulley must be switched from the right hand side of the hitch bracket, to the left, and an additional 3/8 x 1 x 1/2 spacer (B, Figure 3) and 3/8-16 x 2-1/4 capscrew (A) is required. Also install the 1703372 drive belt.

A

B

	F
	E
C	D
Figure 3. Front Pulley - Two-Stage Applications
A. Capscrew, 3/8-16 x 2-1/4	D. Washers, 3/8
B. Spacer, 3/8 x 1 x 1/2	E. Lockwasher & Nut
C. Belt Guide	F. Pulley

Assemble Push Bar Latch

1.Attach Push Bar Latch (B, Figure 4), to hitch. Secure with four .31-16 x 1 bolts (A), and four .38-16 flange nuts (C).

B

C

A

Two Wheel

Four Wheel Drive Models

Drive Models

Figure 4. Assemble Push Bar Latch

A. Bolt, .38-16 x 1 C. Flange Nut, .38-16 B. Push Bar Latch

4