Installation Instructions |
| A |
C | B |
| |
D |
|
B |
|
Figure 5. Assemble Lift Rod |
|
A. Lift Rod | C. Spring |
B. Set Collar | D. Rod Guide |
A
B
Figure 6. Early/Later Lift Links
A.Early Model Lift Link
B.Later Model Lift Link
Assemble Lift Rod
1.Install the set collars (B, Figure 4), spring (C), and rod guide (D) on the lift rod (A) as shown. Final adjustment of the set collars will be made after the hitch and attachment are installed.
Snowthrower
& DozerE
Applications
A
B C D
Mower
Applications
G
A
F C D
INITIAL INSTALLATION
Manual Lift Models
LIFT LINK - EARLY VS. LATER
The early model lift link (A, Figure 6) was used on early production Conquest/1700/2700 Series tractors. It must be replaced with the later model lift link (B) included with this attachment. The later model link works in all appli- cations. Discard the early model link (A).
LIFT LINK POSITION
The lift link is installed differently depending on what attachment is being used. Refer to Figure 7 for link installation information.
Hydraulic Lift Models
1.Fully lower the hydraulic lift. The lift assembly is spring loaded so it will need to be held in the down position to perform of the following procedures.
2.Remove and retain the flat head pin (B, Figure 8) and hair pin clip (E) securing the lift cylinder (A) to the lift shaft assembly (F). Remove and retain the flat wash- ers.
3.Mount the lock plate (D) next to the cams on the lift shaft assembly (F) as shown.
4.Install the original flat head pin (B) and new flat head pin (C) and secure with hair pin clips.
Figure 7. Connect Lift Link
A.Pin
B.Rear Hole of Lift Bar (Snowthrower Applications)
C.Spacer
D.Hair Pin Clip
E.Upper Hole (Snowthrower Applications)
F.Slot of Lift Link (Mower Applications)
G.Lower Hole (Mower Applications)
A |
|
|
B |
| F |
C |
| |
| D | E |
|
|
Figure 8. Install Lock Plate - Hydraulic Lift Models
A. Lift Cylinder | D. Lock Plate |
B. Flat Head Pin (Original) | E. Hair Pin Clips |
C. Flat Head Pin (New) | F. Lift Shaft Assy. |
5
