Assembly
Read entire operator’s manual before you attempt to assemble or operate your new generator.
Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.
If you have any problems with the assembly of your generator, please call the generator helpline at (800)
You will need the following tools to install these components:
•10 mm and 13 mm wrenches
•Socket wrench with 10 mm and 13 mm sockets
•Adjustable wrenches (2)
Install the wheel kit as follows:
1.Tip generator so that engine end is up.
2.Place axle stud (A) through mounting bracket on generator frame.
3.Place a flat washer (B) on axle stud as shown.
4.Use adjustable wrenches to secure the axle stud to frame with jam nut (C).
Unpack Generator
1.Set the carton on a rigid, flat surface.
2.Remove everything from carton except generator.
3.Open carton completely by cutting each corner from top to bottom.
4.Leave generator on carton to install wheel kit.
The generator is supplied with:
•Engine oil bottle
•Operator’s manual
•Wheel kit
Install Wheel Kit
NOTICE Wheel kit is not intended for
5.Place a flat washer (B), then wheel (D) on axle as shown.
NOTICE Be sure to install wheel with raised hub inboard.
6.Use an adjustable wrench to secure the wheel to axle stud with jam nut.
7.Repeat steps 2 through 6 for other wheel.
8.Tip generator so that engine side is down.
9.Line up holes in support leg (E) with holes in generator frame.
10.Attach support leg using two 20 mm bolts (F) and two hex nuts (G). Tighten with 10 mm and 13 mm wrenches.
11.Return generator to normal operating position (resting on wheels and support legs).
12.Line up holes in handle (H) with holes in generator frame. Attach handle using 10 mm and 13 mm wrenches with 35 mm bolts (J) and hex nuts (K).
K
J
H
B
A
D
G
E
F C
7
