5250W Portable Generator
ASSEMBLY
Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.
If you have any problems with the assembly of your generator, please call the generator helpline at
Remove Generator From Carton
1.Set carton on a rigid flat surface with “This Side Up” arrows pointing upward.
2.Carefully open top flaps of shipping carton.
3.Cut down corners at one end of carton from top to bottom and lay that side of carton down flat.
4.Remove all packing material, carton fillers, etc.
5.Remove generator from shipping carton.
Carton Contents
Check all contents. If any parts are missing or damaged, call the generator helpline at
•The generator
•Generator and engine owner’s manuals
•Engine oil
•Three packets of fuel stabilizer
•Wheel kit
INSTALL WHEEL KIT
NOTE: While the wheel kit is designed to greatly improve the portability of your generator, it is not intended for
You will need two 1/2” or 13mm open end wrenches or a socket wrench with 1/2" or 13mm sockets and a needle- nose pliers to install this kit.
Refer to Figure 1 and install the wheel kit as follows:
1.Place the bottom of the generator frame on a flat, even surface.Temporarily place unit on blocks to ease assembly.
Figure 1 — Install Wheel Kit
Capscrew |
|
|
Nut |
|
|
Handle |
| Wheel |
|
| |
|
| Washer |
| Axle |
|
Mounting Leg | Capscrew |
|
| ||
|
| |
| Nut |
|
| 6 |
|
