Assembly
Read entire operator’s manual before you attempt to assemble or operate your new generator.
Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended fuel and oil.
If you have any problems with the assembly of your generator, please call the generator helpline at (800)
Unpack Generator
Install the wheel kit as follows:
1.Tip generator so that engine end is up.
2.Slide axle (A) through both mounting brackets.
3.Place a wheel (B) on each side as shown below.
4.Place a washer (C) on axle and then place an
CAUTION
• Always wear eye protection when installing/removing
1.Set the carton on a rigid, flat surface.
2.Remove everything from carton except generator.
3.Open carton completely by cutting each corner from top to bottom.
4.Leave generator on carton to install wheel kit.
The generator is supplied with:
•Operator’s manual
•Oil bottle
•Wheel kit
Install Wheel Kit
NOTE: Wheel kit is not intended for
You will need the following tools to install these components:
•13 mm wrench
•Socket wrench with a 13 mm socket
•Pliers
•Safety glasses
5.Install
6.Repeat steps 4 and 5 to secure second wheel.
7.Tip generator so that engine side is down.
8.Line up holes in support leg (E) with holes in generator frame.
9.Attach support leg using two short capscrews (M8 x 25 mm) (F) and two locking hex nuts (G). Tighten with a 13 mm socket and wrench.
10.Center handle (H) on generator frame as shown and attach with M8 x 45 mm capscrews (J) and M8 lock nuts (K).
11.Return generator to normal operating position (resting on wheels and support leg).
J
K
H
B
C
A
E
F
D
G
7