Briggs & Stratton manual Quick Setup List, LT-200 Series, while battery is charging, times

LT-200 Series

Quick Setup List -

Page	Setup Procedure	Steps to Perform
4	Uncrating	o Remove Crate & Banding.
		o Place Transmission Release Lever in PUSH position & Roll
		Tractor forward off skid.
4	Battery Charging &	o Charge the Battery (Note: proceed with other setup steps
	Installation	while battery is charging).
		o Install Battery.

5Check Fluid Levels

o o

Check Transmission fluid level. Fill & check Engine oil level.

6	SAFETY CHECKS	o Check for LOOSE HARDWARE.
		o Check all OPERATOR CONTROLS.
		o Test PARKING BRAKE.
		o Perform MOWER BLADE STOPPING CHECK.
		(Blade must stop within 5 seconds!)
		o Check the Seat Switch connection.
		o Perform SAFETY INTERLOCK SYSTEM CHECK.
7	Torque Mower Blades	o Torque mower blades to 45-55 ft.lbs. (61-75 Nm.
7	Burnish Electric Clutch	o Burnish Electric Clutch (run for 15 seconds, repeat 10
		times).

7Reduce &

	Check Tire Pressure	o Reduce & check Tire Pressure.
		(Front Tires 12-15 psi, Rear tires 10-12 psi)
8	Lubrication	o Lubricate all grease & oil points.
10	Mower Assembly	o Install Mower Deck onto Tractor and Attach Belt
		o Level Mower Deck (Side-to-side & Front-to-back).
14	Adjustment Procedures	o Gauge Wheels.

3/2007 3 TP 300-4517-00-RG-N