MAINTENANCE
18
F-030401L
ENGINE MAINTENANCE
Use the following maintenance section to keep
your unit in good operating condition. All the
maintenance information for the engine is in
the “Engine Instruction Book”. Before you start
the engine, read this book.
WARNING: Before you make an
inspection, adjustment (except
carburetor), or repair, stop the
engine and disconnect the wire
from the spark plug.

ENGINE TIPPING

When you service the engine, inspect the
blade, or clean the underside of the mower
housing; make sure to always tip the engine
with the spark plug up (see Figure 11). Trans-
porting or tipping the engine with the spark
plug down will cause:
SHard starting.
SEngine smoking.
SSpark plug fouling.
SOil or gas saturation of the air filter.
Figure 11
HOW TO CLEAN THE MOWER HOUSING
WARNING: The blade will rotate
when the engine runs. Before
you clean the mower housing,
stop the engine and disconnect
the wire from the spark plug.
Grass and other debris can keep the mower
from working correctly. After you mow, clean
the mower housing as follows.
1. Stop the engine.
2. Disconnect the wire from the spark plug.
3. Clean the top and the bottom of the mower
housing.
LUBRICATION
1. For maximum performance, lubricate the
wheels and all pivot points with engine oil
every 25 hours.
2. To lubricate the engine, refer to the “En-
gine Instruction Book”.
NOTE: Do not lubricate the engine stop
cable. Lubricants will damage the cable
and prevent the cable from moving freely.
Replace the cable if bent or damaged.
HOW TO ADJUST THE HEIGHT OF CUT
WARNING: The blade will rotate
when the engine runs. Before
you change the height of cut,
stop the engine and disconnect
the wire from the spark plug.
To change the height of cut, move the position
of the adjuster arm at each wheel (Figure 12).
Make sure each adjuster arm is in the same
position so that the mower will cut level.
1. Disengage the adjuster arm.
2. Move the adjuster arm to another posi-
tion.
Adjuster
Arm
Figure 12