IMPORTANT SAFETY WARNINGS

READ AND FOLLOW ALL SAFETY WARNINGS AND INSTRUCTIONS

IN THE OWNER’S MANUAL BEFORE OPERATING SPOTLIGHT.

WARNING

Never place spotlight lens (face) down when light is on or if it was recently on. Doing so could burn/ignite surfaces such as seats, carpeting, etc. and cause serious property damage. Always turn spotlight OFF and unplug from source when not in use.

To prevent serious damage to eyesight, never look into spotlight when light is on. Do not shine light into the face of someone else.

Do not touch lens of spotlight when light is on or if it was recently on. The lens will be hot and could cause serious burns.

Keep battery clips or cigarette lighter plug dry and out of water at all times.

Do not place spotlight in water. Keep all components dry and out of water at all times.

Do not allow children to handle or operate this spotlight.

Do not use this product for other than its intended use.

Do not operate in close proximity of combustible or flammable materials.

Do not attempt to operate spotlight if cord, plug, bulb or any part of the spotlight is damaged or corroded.

USE CAUTION AND COMMON SENSE WHEN OPERATING YOUR SPOTLIGHT.

FAILURE TO ADHERE TO THE SAFETY WARNINGS AND GUIDELINES IN THIS MANUAL

COULD RESULT IN BODILY INJURY OR PROPERTY DAMAGE.

SAVE THIS MANUAL FOR FUTURE REFERENCE.

Tips to Avoid Damage to Your Q-Beam Spotlight

Never attempt to wipe or clean the inner reflective surface of the reflector. Touching or wiping the surface will damage it permanently.

The lens is made of optical-quality, tempered glass. As with all glass, avoid dropping or sharp impact on spotlight.

Do not allow the hot lens to come in contact with water or materials subject to heat damage.

This spotlight is weather resistant. It is not waterproof. Do not use the spotlight under water or store outdoors for extended periods.

Only use a Brinkmann 12-volt, halogen bulb that is designed for your Q-Beam spotlight. Use of any other bulb may result in poor performance and may damage your spotlight.

After months of use, cigarette lighters can build up corrosion that may prevent your Q-Beam spotlight from making good contact. It may be necessary to clean the inside of your cigarette lighter receptacle with a fine emery cloth. Before cleaning receptacle, remove the fuse to prevent it from shorting out.

1

Page 3
Image 3
Brinkmann 802-1745-0 owner manual Important Safety Warnings, Read and Follow ALL Safety Warnings and Instructions