Brinkmann ProSeries 7751 owner manual Igniter Module Electrode Wire Battery Compartment

Step 3

Remove rotisserie burner cover from rotisserie burner assembly. The bolts and washers removed will be used again in Step 6.

Step 4

Insert the thermocouple bracket through the hole in the back panel. Secure bracket to back panel using three M4 X 8mm bolts, M4 lock washers and M4 nuts.

Step 5

Thermocouple

Bracket

Attach gas supply line to pre-installed rotisserie burner orifice using two M4 X 8mm bolts as illustrated.

Step 6

Replace rotisserie burner cover over rotisserie burner assembly and secure. Make sure rotisserie ground wire is inserted under one of the rotisserie burner cover bolts for a proper ground.

Step 7

Attach the rotisserie burner electrode wire to the igniter module located inside the right door. The connection should be made to the only open terminal.

Igniter

Module

Electrode Wire

Battery Compartment

Step 8

Place hood on the grill and align with holes, then secure hood with hood bolts and cotter pins as shown.

Burner

Orifice

Thermocouple

Wire

Hood

Rotisserie

Burner Cover

Ground

Wire

M4 X 8mm

Bolts

Gas Supply

Line

Cotter Pin

Hood Bolt

Location of

Rotisserie

Burner Igniter

25