Installation: Forward-Facing
Forward-Facing
Lap-Shoulder Belt Installation
•Figure A illustrates the forward-facing lap- shoulder vehicle belt route.
•When not in use, always store the LATCH connectors in storage pouches sewn in cover above
1�Place the child restraint forward facing on the vehicle seat..
•Restraint must be in the full upright position when installed in
•Installation can be improved by the use of the
2�Pull the vehicle belt out, then pass it over the LATCH bar, through the forward- facing belt slots, then over the LATCH bar on the other side (Fig. B).
3�Verify that the vehicle belt is not twisted, then buckle (Fig. C)..
4�Locate the
5�Remove slack from the lap portion of the vehicle belt..
A
B
C
Installation: Forward-Facing
6�Push the child restraint into the vehicle |
|
seat while pulling the shoulder portion |
|
of the vehicle belt tightly through the |
|
| |
• If your vehicle is equipped with an auto- |
|
matic locking retractor (ALR), use of the |
|
| |
is activated. Check your vehicle’s owner’s |
|
manual to determine the type of retractor | D |
your vehicle has. |
7�Hold shoulder belt tight, then rotate the
8�Verify that all connections are secure and the restraint is stable. The restraint is stable when it cannot be moved front to back or side to side more than 1 inch (2..5 cm..) at the belt path..
•See "Checking Buckle Position" on
page 26. | E |
Removal
Disconnect
18 | 19 |