Britax stoller Brake Lever, Lifting upwards, fully extending, Lever up, Down until fully engaged

Introducing your new stroller

Handle

Release Latch with Safety Button

5-Point Harness

Front Swivel Wheel

1. Using your stroller

1A1B

	Hood
Harness	Hood Hinge
Height Adjuster		Backrest
Arm Bar		Adjustment
Leg Rest	Basket	Brake Lever
Swivel
Wheel Lock

1C 1D 1E

1A Open stroller by holding the handle	1B Apply brake when assembling the	1C To attach the arm bar, align moldings	1D To attach the hood with the arm bar
and lifting upwards, fully extending the	stroller. To lock the brake, push the brake	on the arm bar with the metal tabs on	in place, align the hood moldings with the
chassis until it clicks into position.	lever down. To unlock the brake, lift brake	the stroller. Slide both arm bar moldings	plastic tabs on the arm bar and slide them
	lever up.	down until fully engaged. Check for proper	down until fully engaged.
WARNING: Ensure chassis locking devices	IMPORTANT: Always apply brakes when	installation by carefully pulling on the arm	The hood can be fitted without the arm
are engaged before use.		bar.
	parking the stroller.	To remove arm bar, remove hood (if fitted)	bar by aligning the moldings on the hood
			with the metal tabs on the stroller frame
		and slide both arm bar moldings up and off	and sliding them down until fully engaged.
		the metal tabs on the stroller until released.	To remove hood, slide the moldings
		WARNING: DO NOT lift stroller by the
			upwards until released from the tabs on
		arm bar or hood as it may disengage.	the arm bar or stroller.

1E To open the hood, pull the front of the hood forward then push the hood hinges on both sides of the hood down. To close hood, reverse above directions.

1F

1F To recline the backrest, squeeze and release the buckle at the end of the short strap from the buckle housing. Pull the seat-back down and insert the buckle at the end of the longer strap into the buckle housing. To recline the backrest further, release the buckle from the buckle housing and pull the seat-back down.

Reverse the above directions to return the backrest to an upright position.

IMPORTANT: Always support the seat back when adjusting the angle.

1G

C

B

A

1G To secure the child in the 5-point harness, push buckles (A) into buckle housing (B) until buckle prongs snap into position. Carefully adjust the harness by pulling sliders (C) until desired fit is achieved in waist belt, shoulder belts and crotch strap.

To release buckles (A), squeeze top and bottom prongs.

WARNING: Always use crotch strap in combination with waist belt. Always adjust harness when changing child’s seating position.

WARNING: Fasten harness when not in use to prevent it from becoming trapped when folding the stroller.

1H

1H To raise shoulder harness height, pull harness straps through harness height adjuster so that they lay flat on top of the harness height adjusters.

To lower shoulder harness height, thread harness straps through harness height adjuster so they lay flat against the seat back, under the harness height adjuster.

1I

1I To lock the front swivel wheel, push front swivel lock from right to left. To unlock, push front swivel lock from left to right.

2. Folding the stroller

2A 2B 2C

2A Apply brake before folding the stroller. Press and hold safety button on release latch while simultaneously pulling up on release latches.

WARNING: Always remove your child from the stroller prior to folding of stroller.

2B Push handle downward until the stroller folds in half.

2C Fully close and store stroller in a safe, dry space.

IMPORTANT: Do not fold and store the stroller when damp. Stroller should be dry before folding and storing.