MODEL 744SFL
PLAN THE INSTALLATION
POWER |
| 4" ROUND |
|
CABLE | DAMPER/DUCT | ||
| CONNECTOR & | ||
|
| 4” ROUND | HOUSING |
| DUCTWORK | ||
CEILING |
|
| MOUNTING |
JOIST |
|
| |
|
|
| BRACKET |
FINISHED CEILING | TRIM RING / BAFFLE | ||
|
| ||
Typical Installation
The unit can be installed anywhere between ceiling joists using mounting brackets provided. Install in a flat ceiling only.
INSULATION |
|
| |
(Can be placed around and | ROOF | ||
over fan housing.) |
| ||
|
|
| CAP * |
FAN |
|
|
|
HOUSING |
| WALL | |
|
| ||
| ROUND | CAP * | |
* Purchase | DUCT | * | |
separately |
|
| ELBOW(S) * |
Two of the most common ways to connect ductwork to the unit.
The unit will operate most quietly and efficiently when located where the shortest possible duct run and minimum number of elbows will be needed.
Use a roof cap or wall cap that has a
Plan to supply the unit with proper line voltage and appropriate power cable.
COOKING AREA | |
Do not install above or | |
| inside this area. |
45o | 45o |
NOT FOR USE IN | Cooking |
A COOKING AREA. | |
| Equipment |
| Floor |
Do not install in a cooking area.
The unit must not be installed above or inside the cooking area shown.
INSTALLATION | Page 2 |
| |
CARDBOARD PROTECTOR |
|
1. Install mounting brackets.
Slide the adjustable mounting brackets into the bracket channels on the housing.
Bend the tabs on the cardboard protector and insert protector into opening in housing.
NOTE: The cardboard protector shields the inside of the housing from drywall spray and construction dust. Do not remove it until after construction is completed.
1/8" GAP |
2. Mark mounting location.
Position unit between joists and extend mounting brackets.
IMPORTANT: Position brackets so there will be an 1/8” gap between bottom of housing and ceiling material. Mark the top of keyhole slot on all four mounting brackets.
3. Pound in nails.
Remove unit temporarily, and pound nails partially into joists at all four marked locations.
