![](/images/new-backgrounds/1087961/8796119x1.webp)
OPERATION
Controls
The hood is operated using the (5)
The light switch turns the halogen lights on and off. Push the light switch once to turn the lights ON - push a second time to turn the lights ON to a brighter level - push a third time to turn the lights OFF.
LIGHT | BLOWER |
SWITCH | SPEED 2 |
BLOWER
SPEED 3
BLOWERBLOWER
LED LED LED LED
0-1 2 3 4
The blower on-off / speed 1 switch turns the
blower on to its lowest running speed. To turn OFF the blower, push in and hold this blower switch for approximately 2 seconds.
The blower speed 2 switch turns the blower on to
The blower speed 3 and blower speed 4 switches operate the same as blower speed 2 switch except: Blower speed 3 is
After every 30 hours of operation, the LED above the “blower speed 1 switch” will be illuminated (RED) and blink for 30 seconds after turning off the blower. This is a reminder to clean the grease filters. Once the grease filters are cleaned and installed, press in and hold the “light switch” button for approximately 2 seconds during the blink of the LED.
HALOGEN BULBS
This range hood requires four (4) halogen bulbs (Type MR16, 12V, 20W).
ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY BEFORE CARRYING OUT ANY OPERATIONS ON THE APPLIANCE.
To change bulbs:
1.Loosen the ring nut by turning it counterclockwise.
2.Pull the bulb downwards to remove - DO NOT ROTATE. CAUTION: BULB MAY BE
HOT!
3.Replace with Type MR16, 12 volt, 20 watt halogen bulb.
IN CASE THE NEW HALOGEN BULB DOES NOT LIGHT UP ONCE IT IS ON, CALL FOR SERVICE.
- 10 -
BULB
RING NUT