MODELS QP430SS • QP436SS • QP442SS
PREPARE THE HOOD
3 | Remove parts bag and 3¼” x 14” damper/duct connector |
| from inside the hardware box included with the hood. |
4 | Remove all protective polyfilm from the hood. |
5 | Remove 6 Screws holding Bottom Pan to hood. Set bot- |
| tom pan and screws aside. |
SCROLL |
CAP |
BUSHING |
SCREWS |
LIGHT PANEL |
6 FOR 30” MODEL ONLY:
Remove
Remove Rubber Bushing in Scroll Cap. Set parts aside.
7” ROUND
KNOCKOUT
PLATE (also
remove 3¼” x 14”
vertical plate)
| 3¼” X 14” |
| VERTICAL |
| KNOCKOUT |
3¼” X 14” | PLATE |
HORIZONTAL |
|
KNOCKOUT |
|
PLATE |
|
7 Remove 3¼” x 14” vertical, 3¼” x 14” horizontal, or
method.
Page 6
| 3¼” X 14” |
TOP/BACK | DAMPER / DUCT CONNECTOR |
| |
EDGE OF | DAMPER |
HOOD | |
| FLAP |
| PIVOT |
| 7” ROUND |
| DUCT |
| PLATE |
8 VERTICAL 7” ROUND & 3¼” X 14” INSTALLATION ONLY:
Attach 3¼” x 14” Damper/Duct Connector (if using 3¼” x 14” duct) or 7” Round Duct Plate (if using
Notes:
To accomodate
of the hood center and the 7” round duct plate can be installed up to ½” on either side of the hood center.
Install the 3¼” x 14” Damper/Duct Connector with the Damper Flap Pivot nearest the Top/Back Edge of Hood.
9 HORIZONTAL 3¼” X 14” INSTALLATION ONLY: Remove and discard Vertical Diverter Plate.