Broan warranty Prepare The Hood, ALLURE QS3 SERIES RANGE HOOD, Page, to Top/Back Edgeof hood

ALLURE® QS3 SERIES

RANGE HOOD

®

Page 4

PREPARE THE HOOD

PREPARE THE HOOD

TOP RECTANGULAR

DUCT KNOCKOUT (Remove for 3¼” x 10” Vertical & for 7” Round Discharge)

REAR

RECTANGULAR

DUCT KNOCKOUT (Remove for 3¼” x 10” Horizontal Discharge)

SEMI-CIRCULAR DUCT KNOCKOUT (Remove for 7” Round Discharge)

TAPE	TOP/BACK
UP TO 1”	EDGE
SIDE-TO-SIDE
ADJUSTMENT

➙➙

DAMPER/

PIVOTDUCT CONNECTOR

(Vertical discharge position shown)

13 3¼” x 10” Ducted Discharge Only: Remove Tape from

damper flap and attach Damper/Duct Connector over

knockout opening with screws removed in Step 4 under

11Remove appropriate Duct Knockout(s) from top or back of hood.

“PREPARE THE HOOD”. Make sure damper Pivot is nearest

to Top/Back Edge of hood.

14 7” Round Ducted Discharge Only: Re-install 7” Round Duct

Plate removed in Step #1 under “PREPARE THE HOOD”.

Install a 7” round damper (purchase separately). Damper

SCREW

TIES

flap must open freely in direction of airflow (away from range

hood).

NOTE To accomodate off-center ductwork, the Damper/Duct Connector can be installed up to 1-inch on either side of hood center or the 7” Round Duct Plate can be installed up to ½” on either side of hood center. In extreme off-center installations, one end of the duct connector may need to be trimmed to clear the electrical cable clamp.

METAL STRIP PLATE

12Horizontal Discharge Only: Remove the Plate in front of the horizontal discharge knockout. Cut the Ties, lift plate out, and discard plate. DO NOT REMOVE the Metal Strip held in

place with two Screws.