Broan QS3 SERIES Ducted Installation - Skip to Step, The following Steps 5 thru 10 are for, Page

	ALLURE® QS3 SERIES
	RANGE HOOD
	Page 3
PREPARE THE HOOD	PREPARE THE HOOD

ELECTRICAL

CABLE CLAMP

4 Remove either top or back wiring knockout and install approved Electrical Cable Clamp.

Ducted Installation - Skip to Step 11.

The following Steps (5 thru 10) are for

NON-DUCTED INSTALLATION ONLY.

(3) #8 SCREWS
(2) #8 SCREWS	LIGHT
	PANEL

6	Remove Air
	Chute - held in
	place with one
	(1) screw.

NOTE: Be careful not to disconnect any wires.

7	Remove Baffle
	from air chute.
	Tabs will
	disengage
	from Slots.

AIR CHUTE

BAFFLE

SLOTS TABS

➙

➙

SUPPORT FIN

5 Remove Light Panel - held in place with (3) #8 screws and (2) #8 screws. Disconnect light assembly wire harness

(white connector).

8	Rotate baffle. Reinsert
	baffle into air chute (as
	shown) so that baffle	➙
	fits all the way into
	into air chute. An
	audible “click” will
	be heard when
	fully installed.
	This will direct
	air flow through
	the non-ducted	➙
	slots on top
	of hood.
9 Re-install air chute and screw,
	re-connect wire harness, and replace light panel.

NOTE: Be careful not to trap wires between Support Fin and light panel.