2.Attach an adequate length of 6” round steel ducting to the range hood duct connector. Fig.6
3.Duct tape all joints to make them secure and air tight.
4.Carefully place the lower decorative flue into the recessed area of the range hood top. Fig. 7
5.Carefully slide the upper decorative flue down inside the lower flue. Fig. 7
INSTALL THE HOOD
Note: at least two people will be required to mount the hood.
UPPER | UPPER |
FLUE | |
FLUE | VENTS |
| EXPOSED |
LOWER | UPPER |
FLUE | |
| FLUE |
| VENTS |
| CONCEALED |
| BEHIND |
| LOWER |
| FLUE |
| fig.7 |
1. | Raise | the hood into its | HEIGHT | WALL FRAMING | ||
| mounting position. | ADJUSTMENT | ||||
|
| |||||
|
|
|
|
| SCREWS |
|
2. Plug the power cord into | (3.9x9.5mm) |
| ||||
|
| |||||
| the electric wall recep- | MOUNTING |
| |||
| tacle. Tuck excess cord | SCREWS |
| |||
| behind the flue. | (4.8x38mm) |
| |||
|
| MOUNTING | ||||
|
|
|
|
|
| |
3. | Align | the | rectangular |
| BRACKET | |
|
| |||||
| opening on the back of the |
| MOUNTING | |||
| hood | with | the wall- |
| ||
|
| SCREWS | ||||
| mounting bracket. Gently |
| ||||
|
| (4.8x38mm) | ||||
| lower the hood until it |
|
| |||
| securely | engages the |
|
| ||
| bracket. | Fig.8 |
| RECTANGULAR | ||
4. | Level the hood. |
| CUTOUT fig.8 | |||
|
| |||||
| Height adjustment screws provide |
| ||||
| vertical adjustment. |
| FASTEN FLUE TO | |||
| Secure the hood with mounting screws | UPPER BRACKET | ||||
| (4.8x38mm). Use drywall anchors, | WITH SCREWS (3.9x9.5mm) | ||||
| provided, if wall studs or framing are not |
| ||||
| available. |
|
|
|
| |
| Secure with (2) mounting screws |
| ||||
| (4.8x38mm). Use drywall anchors provided |
| ||||
| if wall studs or framing are not available. |
| ||||
| Fig.8 |
|
|
|
|
|
5. Raise the upper flue until its holes align |
| |||||
| with holes in the flue mounting bracket |
| ||||
| (located on ceiling). Fig.9 |
|
| |||
6. Secure the flue with (2) mounting screws | fig.9 | |||||
| (3.9x9.5mm). Fig.9 |
| ||||
|
|
|
7