OPERATION
Controls
The hood is operated using the slide controls under the bottom of the hood.
The light switch turns the lamps on and off.
The blower switch :makes it possible to select the motor operating speed. Position 0: motor off.
The pilot lamp lights up whenever the blower is on.
LIGHT BLOWER
SWITCH SWITCH
PILOT LAMP
HEAT SENTRY™
Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a device that will turn on or speed up the blower if it senses excessive heat above the cooking surface.
1)If blower is OFF - it turns blower ON to HIGH speed.
2)If blower is ON at a lower speed setting - it turns blower up to HIGH speed. When the temperature level drops to normal, the blower will return to its original setting.
WARNING
The HEAT SENTRY thermostat can start the blower even if the hood is turned OFF. When this occurs, it is impossible to turn the blower OFF with its switch. If you must stop the blower, do it from the main electrical panel.
HALOGEN BULBS
This range hood requires two halogen bulbs (Type GU10, MR16 shielded, 120V, 50W).
ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY BEFORE CARRYING OUT ANY OPERATIONS ON THE APPLIANCE.
1.Remove the grease filters.
2.Remove the metal grille by turning the (2) knobs counterclockwise.
3.Loosen the ring nut by turning it counterclockwise.
4.Loosen the bulb by turning it counterclockwise; pull the bulb downwards to remove. CAUTION: BULB MAY BE
HOT!
5.Replace with Type GU10, MR16 shielded, 120V, 50W halogen bulb.
KNOB
METAL GRILLE
GREASE FILTERS
BULB
RING NUT
- 9 -
