Broilmaster PCB1-2, DCB1-2, SS26P-1, SS48G-1, BL26P-1, B101652 Protective Film Side Cover Plate

In-Ground Post Assembly

3.Attach the grease cup bracket assembly to the bottom of the grill casting and fasten with #10-24 x 3/4” bolt, 9/32 ID x 5/8 OD washer, and #10-24 wing nut. See Figure 6.

Use only the supplied grease cup or noncombustible contain- ers for the grease cup (aluminum or tin cans). DO NOT use combustible containers such as paper or Styrofoam cups.

Note: Grill top comes assembled to the bottom. For ease of as- sembly, remove grill top.

6.Place the grill bottom on top of the post and secure the grill bottom to the post by placing four 1/4-20 x 3/4 Hex Head screws and 1/4 x 5/8 Flat Washers in the threaded inserts that are in the upper bracket. See Figure 6.

Figure 3

4.For Grill Heads other than R3 Series, continue on to Step 5.

For R3 Series Grill Heads: Bend the tabs on the Post Cover Plate to 90° as shown in Figure 4. Two different size cover plates are included with the R3 Series Grill Heads. Choose the plate that will best fit your post.

Note: If using the stainless steel Post Cover Plate, bend the tabs so they face away from the protective film. Remove the protective film after bending the tabs.

Figure 6

Installing old grill head P3 or P4 to new patio post.

A B101668 kit will need to be used to cover the opening in the post. See the instructions with the kit for further installation information.

PROTECTIVE

FILM SIDE

COVER PLATE

Figure 4

5.For R3 Series Grill Heads: Slide the Post Cover Plate onto the front of the post. Slide the Upper Brack-

et onto the post. Secure the Post Cover Plate and Up- per Bracket to the top of the square post using four #10 – ½ Hex Head screws. See Figure 5.

For Grill Heads other than R3 Series: Slide the Upper Bracket into the post. Secure the Upper bracket to the top of the square post using four #10 – ½ screws. See Figure 5.

Figure 7

	Figure 5
B101586-7-1012	Page 21