Broilmaster SKFB2-1 Broilmaster, Solid Surface Drop-Down Side Shelf, Correct Bracket Alignment

Drop-Down Side Shelf Installation

Solid Surface Drop-Down Side Shelf

1.Remove the cooking grids, briquets and briquet rack from the grill.

2.Attach the Bracket Attach Assembly to the grill using the Truss Head Screws, Flat Washers, Lock Washers, and Nuts. See Figure 1. Note: Ensure that the Bracket Attach Assembly is installed so that the match light access hole is on the bottom. See Figure 2

3.Place the Side Shelf upside down on a clean surface and use the four coarse-thread screws to loosely attach the Support Brackets.

4.Place the support stiffener on the inside of the shelf using (2) #10-16x1/2” screws to secure in place.

5.Hang the shelf brackets on the lower pins of the Bracket Attach Assembly. Tighten the four screws to secure the bracket arms to the shelf. See Figure 3.

6.To raise the shelf - swing it out and lift the notches over the upper pins. Make sure the shelf is securely in position before placing any- thing on it.

7.To lower the shelf - lift up on both brackets simultaneously and pull out slightly.

Correct Bracket Alignment

Figure 1

Incorrect Bracket Alignment

Figure 3 Figure 2

BROILMASTER®

A Division of Empire Comfort Systems, Inc.

918 Freeburg Ave.

Belleville, Illinois 62220

	Visit our web site at www.broilmaster.com
	If you have a general question about our products, please e-mail us at info@empirecomfort.com.
Page 4	If you have a service or repair question, please contact your dealer.	B101559-3-0611