Brookstone MAX 2 manual Massager OPERATION, Charging the Massager, Turning Power On and Off

Massager OPERATION

Charging the Massager

Important! Fully charge the massager for 2 hours before first use.

1..To charge the massager, connect the Adapter to the massager and plug it into a wall outlet..

2..The one through five SPEED LEDs will illuminate sequentially while charging, and they will all remain illuminated when charging is complete..

3..A completely depleted massager battery will take up to 2 hours to charge..

4..The average run-time for the battery at the highest setting is 3 hours..

5..The SPEED LEDs will flash green when the massager’s battery needs to be recharged..

Note: You may also use the massager while it is plugged in to the electrical outlet, however, the massager’s battery will not charge while in use.

Turning Power On and Off

1..Press POWER.. When the massager is first turned on, all five green Speed LED lamps light up, from Speed 1 to Speed 5.. The blue Program lamps (SOOTHING, ENERGIZING and PULSING) light up once sequentially.. The motor then runs at its top speed (Speed 5)..

2..Press POWER again to shut off.. The motor stops and all SPEED LED lamps shut off..

Note: The massager will automatically shut off after 20 minutes.

7